Download 23061 - LA-SNSJMBLB-6/24 Operating Instructions and Precautions
Installation: Select a smooth flat mounting surface for the light. Be sure to thoroughly clean and dry the surface. Remove the metal mounting disc from the back of the light. Carefully peel the protective backing from the disc. Be careful, the exposed adhesive is very sticky! Press the adhesive side of the mounting disc to the mounting surface and press firmly and evenly on the disc. Allow the metal disc to cure for 24 hours before placing the light. After the adhesive has cured for 24 hours, place the magnetic back of the light bar on the mounting disc. Your light is ready to use. Warning: Mounting disc cannot be removed easily once installed!
Sensor Mode: Slide the power switch to the "auto" position. The light will come on. If there is no motion in the field of the sensor, the light will shut off after 15 seconds. After that, the light will come on if motion is detected within the operating field of the sensor on the light. The light will stay on while motion is detected and shut off after 15 seconds.
Please Note: The light only operates in very dark environments in the sensor mode. The motion sensor must face the area directly where you want to detect motion. The motion sensor detects movement up to 10 feet away.
Manual Operation: To turn the light bar on manually, slide the power switch to the “on” position. To turn the light off, slide the power switch to "off." The light bar may be operated while mounted, or handheld as a Grab & Go® flashlight.
Battery Replacement: Remove the battery compartment cover by pressing on the ribbed area and sliding it off. Install 4 new AA alkaline batteries, negative end first, as shown on the diagram inside the battery compartment. Slide the battery compartment cover back on in the direction of the arrow until it clicks.
Important: If you will not be using this light for up to 30 days, you should set the mode switch to the "off" position. For longer periods of time, such as storage, remove the batteries to prevent damage or drain.
Caution: Replace all batteries at the same time. Do not install batteries backwards, charge or put in fire. Do not mix old and new batteries. Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Ni-Cad, Ni-Mh, etc.) batteries. This may cause batteries to leak or explode. Old or discharged batteries must be recycled or disposed of properly, according to local regulations.
Warning! To prevent serious injury, including temporary or permanent loss of sight do not stare into the light, shine light into eyes or focus the beam using an additional lens. Keep away from infants and toddlers as this product contains small parts.
This product is not a toy! Use this light only as it is intended. Inspect before every use. Do not use if parts are damaged, loose or missing.
Save these safety precautions.
